| 工作电压 |
220（V） |
报警电流 |
10（mA） |
| 探测角度 |
360° |
静态电流 |
10（uA） |
| 工作温度 |
-10~+40（℃） |
探测距离 |
1-6（m） |
| 适用范围 |
吸顶安装系列 |
类型 |
红外探头感应器 |
Power source: 110-130V/AC 60Hz220-240V/AC 50HzRated load:1200W Max.tungsten(220-240V/AC)300W Max.fluorescent(220-240V/AC )600W Max.tungsten(100-130V/AC)150W Max.fluorescent(100-130V/AC)Standby power: working 0.45W (static 0.1W)Time setting: 10sec-12minDetection range: 3-10m (radii.)Light-control: 2LUX~2000LUXDetection angle: 360º (ceiling installation)Installation height: 2.5~3.5mWorking temperature: -10°C~+40°CDetection motion speed: 0.6~1.5m/sFUNCTION￡oYou can manually adjust the time setting, Sensitivity and light-control (For detail: see 1.knob setting); it is very easy to use.Install Sensor at 2.5~3.5m position on the wall (For detail: see 3. installation instruction) and connect the wire according tothe 2. connection figure. Switch on power, after about 1 minute the unit enter stable working state. Here please turn TIMEknob to the position close to minimum, and turn LUX to sun for testing. If it works normally, turn the TIME knob to theminimum” IMPULSE” position( ). When it senses again, the controlled lamp will be turned on and off regularly. If the abovetests go through, then select the time, light-control and sensitivity to your need. So its installation is ok.
点击图片查看原图
产品分类